KKT KOLBE EASY Benutzerhandbuch Seite 58

Mounting the hood
9. Mounting the hood
Edges and internal components can be
sharp-edged and cause injuries.
Exercise appropriate caution and pro-
tect yourself if necessary, e.g. with work
gloves.
For installation on solid masonry,
proceed as described below.
If the appliance is to be mounted on a
different type of wall (e.g. plasterboard,
aerated concrete, Poroton brick), replace
the mounting material according to the
substrate.
If the mounting surface is made of wood,
you can do without the dowels.
However ensure a secure hold.
• Determine the desired position for
mounting the hood body support
bracket centrally above your hob
according to the previously mentioned
distance regulations and dimensions.
Note: The hood will later be suspen-
ded from the bracket on the rear up-
per edge. To be sure, you can also fix it
beforehand and pre-align it optically.
• Place the hood body support bracket
horizontally at the desired position
on the wall using a spirit level and
mark the position of the screw holes.
58
• Drill a hole at each of the marked
positions according to the diameter
of the dowels.
• Then carefully tap a dowel into each
of the holes with a hammer and fasten
the bracket to them with the screws
provided (4.2 × 30 mm).
boreholes
dowels
support
bracket
• Raise the hood body and attach it to
the wall bracket.
screws