EINHELL FSM 720 NIRO Bedienungsanleitung Seite 5

Anl. FSM 720 12-sprachig
Wear goggles
Wear ear-muffs
1. Technical data
Motor rating:
Motor speed:
AC motor:
Insulation class:
Protection type:
Power lead:
Length of cut:
Length of jolly:
Cutting height:
Cutting table:
- Dimensions
- Material:
Diamond cutting wheel
Weight
Noise emission values
The noise produced by this tile cutting machine
is measured in accordance with DIN EN ISO
3744; 11/95, DIN EN ISO 11201: 1996-07 ISO
7960 Annex A; 2/95.
The level of noise at the workplace may exceed
85 dB(A). In this case it is essential to take
suitable precautions to protect the user's hearing
(wear ear muffs!).
Sound pressure level LPA 92,0 dB(A)
Sound power level LWA
2. Important notes
Please read this operating manual carefully and
follow the instructions. Use the manual to familiarize
yourself with the machine, its proper use and safety
instructions.
06.11.2001 13:41 Uhr
630 W S3 30s/90s
2800 rpm
230 V ~ 50 Hz
Class F
IP 20
H 05 RN-F 3x0,75
unlimited
unlimited
45 mm
394 x 394 mm
Inox steel
ø 200 x 25.4 x 1,8
10 kg
Working mode Idle
62,7 dB(A)
100,2 dB(A) 69,2 dB(A)
Seite 5
Important!
For safety reasons it is prohibited for children, young
people under the age of 16 years and all persons
who have not read and understood the operating
instructions to use the tile cutting machine.
3. Description of the machine
Portable tile cutting machine for medium tiles
Cutting performed by a diamond cutting wheel.
Jolly cuts with tilting work top up to 45 degrees.
Cutting wheel cooled with water.
Straight fence and mitre fence.
Removable trough as cooling water container.
(To remove: Pull out the trough as far as the stop
and then lift slightly to remove completely.)
4. Intended use
The FSM 720 NIRO tile cutting machine is designed
to perform cutting jobs on small and medium tiles
(floor and wall tiles made of ceramic and similar
material) which suit the machine's size. It is intended
in particular for use by DIY enthusiasts and
craftsmen. The cutting of wood and metal is
prohibited. The machine is to be used solely for
its intended purpose. Any use other than its
intended use is a case of mis-use. The user/operator
and not the manufacturer shall be liable for any
damage or injury resulting from cases of mis-use.
Only those cutting wheels suitable for the machine
are to be used. The use of saw blades is prohibited.
For the machine to be used as intended it is also
imperative to observe the safety instructions, the
assembly instructions and the operating instructions
set out in this manual. All persons entrusted with
operating and servicing the machine must be
acquainted with the manual and must be informed
about the machine's potential hazards. It is also
imperative to pay exact attention to the accident
prevention regulations in force in your country and to
observe the general rules of occupational medicine
and safety. The manufacturer can accept no liability
whatsoever for damages resulting from any
modifications to the machine. Even when the
machine is used as intended, certain residual risk
factors cannot be ruled out completely. The following
hazards may arise in connection with the machine's
design and construction:
Touching of the diamond cutting wheel in the
uncovered zone.
Reaching into the area of the diamond cutting
wheel when it is running.
Catapulting of a faulty diamond tip off the cutting
wheel.
GB
5