BEMIS PURE CLEAN 5000 Gebrauchsanweisung Seite 20

EN | REMOTE CONTROL FUNCTIONS
button to start the back and forth cleansing. During swing mode press the spraying arm
forward or backward button to adjust the nozzle position. Swing mode stops by pressing
the swing mode or stop button.
• Auto-cleaning function: Press the auto-cleaning button to start the cleaning program.
• Ceramic sterilization: Do not sit on the toilet and make sure the cover is closed. Press the
sterilization button to start the UVC-sterilization program. The program lasts 10 minutes,
when the cover is opened the program stops and continuous when the cover is closed
again. The duration of the program is not reset.
• Water flow adjustment: The water flow can be adjusted under the rear/bidet wash mode.
Press the rear/bidet wash button again during wash mode to increase or decrease the
water flow. There are 3 water flow pressure settings, high, medium, low, the default set-
ting is medium.
• Seat temperature adjustment: Every time you press the seat temperature plus key, the
seat temperature increases by one level. Every time you press the seat temperature minus
key, the temperature decreases by one level. The corresponding indicator lights, light up
with each level. Press the minus key ones more to turn the seat temperature function off,
all indicator lights will be off.
• Air temperature adjustment: Press the dry button to start drying. During drying mode,
each time you press the button, the air temperature will be adjusted by one level, to the
maximum of three. The corresponding indicator lights, light up whith each level. The
levels will be cyclically adjusted and closed. All indicator lights will be off when closed.
• Water temperature adjustment: During rear/feminine wash mode, each time you press
the water temperature button, the water temperature is adjusted by one level, to the max-
imum of three. The corresponding indicator lights, light up whith each level, the default
setting is medium. The levels will be cyclically adjusted and closed.
• Nozzle position adjustment: Press the spray arm forward or spray arm backward button
to adjust the nozzle position forwards or backwards. Move to the limit position, and then
press the spray arm forward or spray arm backward button, the nozzle does not move.
• Cover open: Press the cover open button to control the opening and closing of the lid.
• Cover + Ring open: Press the cover & ring open button to control the opening and clos-
ing of the ring and cover.
• Eco mode: Press the energy saving button to turn on or off the energy saving mode. After
pressing the energy saving button, the seat temperature will be automatically adjusted
to the lowest level when the seat temperature is heated, and it will remain closed when
the seat temperature heating is turned off. In the energy-saving mode, all display lights
are turned off. In the energy-saving mode, the seating sensor detects that someone is
seated, and automatically stops the energy-saving mode, and automatically enters the
energy-saving mode after the user leaves the seat.
• Ceramic ambient light: When not seated, press and hold the stop button on the remote
control for 5 seconds to turn on or off the ceramic ambient light.
• Night light function: By default the nightlight is turned on. Press the night light button
shortly to turn on or off the nightlight function. Long press the nightlight button to acti-
vate the light sensitive response function which turns on or off the nightlight according to
the light intensity in the bathroom.
• Descaling: In non-seated state, after adding descaling liquid, press the descaling button
to turn on or off the descaling program. During descaling, the activation button shows a
green light.
20