EN | SAFETY PRECAUTIONS
•
Please be considerate of low temperature burns. Low temperature burn may occur
when the skin has been in contact with an object at relatively low temperature (about
40ºC). Close supervision is necessary when this product is used by children or adults
with sensitive skin.
•
Please pay attention to the correct electrical installation of this product. The electrical
socket needs to be a waterproof socket. The installation position of the power socket
must be more than 0.5m above the floor, and away from shower and bathtub, otherwise
it might cause electricity leakage.
•
This product must be effectively grounded and installed correctly before use.
ATTENTION
•
Do not use benzene, any acid chemical-based detergent, putty powder or non-neutral
detergent / cleanser to clean the plastic parts like toilet seat cover, inner ring or other
plastic components. Only neutral detergent permitted. Do not use a nylon brush or
other harsh tools to clean the plastic parts like toilet seat cover, inner ring, or other
plastic components. Only a soft cloth or sponge is permitted.
•
Allow the seat and lid to close automatically. Do not force the lid closed.
•
In the same room where this product is installed, it is recommended to install a water
shutoff valve at an accessible point which can cut off the water supply in case of an
emergency. Otherwise, the unexpected failure of this product may cause water
damage.
•
Drain the water from the unit and unplug the power if this product is not going to be
used for an extended period of time.
•
When the temperature outside is lower than 0℃, please close the water inlet angle
valve and empty the water in the water inlet pipe and accessories to prevent the water
inlet pipe or external filter and other accessories from being damaged due to freezing.
If the product pipe has been frozen, please raise the room temperature and wait for the
ice in the pipe to melt before using it. Otherwise, the product may not be used
normally.
•
Please place the product in the shade, do not directly expose it to the sun, otherwise
the product will fade, or the surface of the product will be burned by the sun due to
unstable temperature.
•
Connect this product to a cold-water supply pipe carrying potable water. Do not
connect to an industrial water supply line that does not carry water of drinking quality.
This will negatively affect hygiene and performance.
16