BEARWARE 20200528HK016 Bedienungsanleitung Seite 33

5. Once you complete this process, press and hold the "ALERT" button for
about 3 seconds. The display changes back to the time mode. Alternatively,
the device automatically returns to the time mode after about 60 seconds
after the last button is pressed.
When the alarm is activated, it can be heard audibly and the icon flashes on the
display. Press the "ALARM / SNOOOZE", "ALARM" or "ALARM" button to stop the
alarm. If you ignore the alarm, it is stopped after 2 minutes.
Note: You cannot enter contradictory HIGH / LOW values in the setting. If the
HIGH temperature value, for example, is 40° C, you cannot set the LOW alarm to
more than 39.9 °C, etc.
When an alarm is activated in Auto Cycle mode, the display switches to the
corresponding channel. You can press "ALARM / SNOOZE", "ALARM" or "ALERT".
Alternatively, the alarm stops automatically if you do not use the device for 2
minutes. The display returns to Auto Cycle mode.
History
The main unit stores all the measured values of the last 24 hours. Press the
"HISTORY" button on the back of the device to see the history. The time at which
the displayed values were measured and the values are displayed instead of the
current time. Press the "HISTORY" button again to switch between the last 24
hours of the history.
Caution!
9. Safety instructions and disclaimer
Never try to open the device to repair or make modifications. Avoid contact with
the mains voltage. Do not short-circuit the product. The device is not waterproof,
hence please use it only in dry surroundings. Protect it from high humidity, water
and snow. Keep the device away from high temperatures. Do not expose the de-
vice to sudden changes in temperature or strong vibrations, as this could damage
the electronic components. Check the device for any damage before using it. The
English
33