BEARWARE 20200528HK016 Bedienungsanleitung Seite 32

RECORDING MAX / MIN TEMPERATURE
The main unit stores the MAX / MIN temperatures recorded since the last manual
reset.
1. Press the "MEM / -" button once In time mode to display the maximum tempe-
rature measured in the current channel
2. Press the "MEM / -" button repeatedly to display the MAX / MIN value in the
following sequence: The maximum temperature of the current channel -> The
minimum temperature of the current channel -> The maximum humidity -> The
minimum humidity -> The maximum indoor temperature -> The minimum indoor
temperature -> The maximum humidity -> The minimum humidity -> The maxi-
mum air pressure -> The minimum air pressure.
3. When the MAX / MIN readings are displayed, the display returns back to
normal mode after 5 seconds.
4. To clear the MAX / MIN indoor readings or that of the current channel, press
and hold the "MEM / -" button for 2 seconds once the device is switched on and
is in the MAX/MIN display.
Temperature/ Humidity alarm setting
The device can set a HIGH / LOW alarm for indoors and up to 8 outdoor channels.
1. Press and hold the "ALERT" button for about 3 seconds in time mode to
access the alarm settings. The "IN" symbol starts flashing.
2. By pressing "CHANNEL / +" or "MEM / -" button you can select the channel
to be adjusted. Start adjusting the channel using the "ALERT" button.
3. Press the "CHANNEL / +" button or the "MEM / -" button to change the
value. Press the "ALERT" button to confirm this setting and to go to the
next menu item. The setting sequence is as follows: Temperature "HIGH"
-> Temperature "LOW" -> Humidity "HIGH" -> Humidity "LOW" -> Channel
selection.
4. To set the alarm value, press the "ALARM" button at the top of the weather
station to turn the temperature alarm on or off. A "
next to the corresponding temperature alarm, if it is enabled.
32
" symbol is displayed
English