Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation and Connection
42
All manuals and user guides at all-guides.com
Connecting the modules
1)
Strip approx. 6 mm of insulation from the individual wires. Use a suitable tool for this
purpose (e.g. stripping pliers)
Figure 9: Conductors in correct sequence
2)
Arrange the wires in the correct sequence; see connection scheme above.
3)
Insert the wires one after the other in the terminal. Push the wires into the terminal until
you feel a slight resistance. Using flat-nose pliers will make this easier. Make sure the
stripped portion of the wire is not too long and does not project from the terminal.
Shorten the core if necessary.
Figure 10: Connecting the wires
4)
Fasten the CAT cable to the adjacent retainer with a cable tie. The strain relief prevents
the wires from being torn out of the terminal if the cable is pulled.
Figure 11: Strain relief of the CAT cable
5)
If the connected module is not the last module in the series, insert the further portion of
CAT5 cable into the second terminal of the correct socket in the same way.
6)
The last module does not require any termination or similar device.
7)
Install the module in the mounting box. Follow the instructions under Fitting the modules
(Page 38)
Fitting the modules
Fitting the modules
Fitting the modules
AMM 10
Werbung
