Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation and Connection
3 Installation and Connection
Fitting the modules
38
All manuals and user guides at all-guides.com
RISK OF INJURY!
The devices must only be installed by authorised technicians.
ATTENTION
Observe the following basic requirements prior to installation:
• Install the modules only in dry rooms.
• For installation use deep mounting boxes with an internal depth of at least 55 mm.
• Clean any dust and other impurities from the mounting frames and mounting boxes. If
necessary use a damp, but not wet, cloth.
The following criteria must be satisfied during installation:
• When installing, avoid proximity to parts under mains voltage.
• Use only shielded CAT5 cable.
It is permitted to use a CAT 5 cable with a conductor cross-section of not less than 0.12
mm² (AWG26) and not more than 0.5 mm² (AWG20).
• The PSU 10 power supply unit must be mounted directly adjacent to the control and
master output module, as the operating voltage is supplied here.
• The optional REC OUT module must be installed one slot away from the control and master
output module.
• Make sure that the shield and the drain wire do not touch any electronic components.
Assembly sequence
The assembly sequence is always the same, whether it is in a cavity wall box, a flush or
surface-mounted box, a cable duct or a desktop case.
NOTE
Make sure that the CAT5 cable has been correctly laid as far as the installation location.
AMM 10
Werbung
