Harman AKG AMM 10 Bedienungsanleitung Seite 40

Installation and Connection
ATTENTION
Connecting the modules
ATTENTION
NOTE
ATTENTION
40
All manuals and user guides at all-guides.com
3) Connect the module as described under Connecting
4) Align the module and screw it tight.
RISK OF DAMAGE!
Guide the module carefully and precisely into the mounting box. Make sure that the metal drain
wire does not touch any electronic components and that none of the wires gets trapped or their
insulation damaged.
Figure 5: Fastening a module
Preparing the cabling
Once you have fitted all the necessary mounting boxes and laid the CAT5 cable, you can start
installing the modules.
RISK OF INJURY!
The PSU 10 power supply unit must be connected last.
This module may only be installed by qualified technicians, observing relevant technical
regulations and VDE directives.
Connection of the protective earth (PE) conductor is obligatory.
Remember that the PSU 10 power supply unit and the optional REC OUT module have to be
next to each other due to the length of the connecting cable.
CABLE LENGTH
Before cutting the CAT5 cable, remember to leave enough length in reserve.
Installing in cable ducts:
The cable should project by approx. 20 cm from the cable duct so that the module can be
connected easily. A certain amount of cable can be left in reserve in case you want to move
the frames in the cable ducts later on.
Flush mounting:
Insert the modules without applying much force. When choosing the cable length make sure
there is enough space in the box for the installed module.
RISK OF DAMAGE!
Too much spare cable in the flush-mounted box can damage the cable or the circuit board.
Pressing the circuit board against a cable may damage or even cut through it. Shorten the cable
if necessary.
Connecting the modules the modules (Page 40).
Connecting Connecting the modules the modules
AMM 10