Harman AKG AMM 10 Bedienungsanleitung Seite 41

All manuals and user guides at all-guides.com
NOTE
NOTE
AMM 10
Stripping the CAT cable
1) Score the CAT cable about 5 cm from the end and remove the sheath. Take care that you
do not cut into or through the individual wires.
Figure 6: De-sheathing the CAT cable
2) Remove the shielding. Take a side cutter and cut into the shielding. The shield can now
be removed so that the four wire pairs and the drain wire become visible.
Figure 7: Removing the shielding
REMOVING THE SHIELDING
Ease a side cutter carefully under the shielding and cut into it a little. After that it can be
loosened easily.
EARTH POTENTIAL
Be very careful that you do not cut the metal drain wire of the CAT cable as this is needed for
earth potential!
Wiring the modules
To avoid confusion, sort the wires into the correct colour sequence. All modules, if attached to
the "bus", are always connected in the same sequence:
Figure 8: Wire connection scheme
1 = White-green 2 = Green
4 = Blue 5 = White-blue
7 = White-brown 8 = Brown
Installation and Connection
3 = White-orange
6 = Orange
9 = Drain wire
41