Studer Revox B250-S Bedienungsanleitung Seite 47

Auxiliary keypad Record (REC=IN, REC-OUT)
ecordin There are two ways of making a recording.
R g The audible signal source can also be the re-
cording source or a different source can be
selected for recording.
This setting is selected before the amplifier
leaves the factory. The display [15] shows the
selected signal source, the volume control
and balance settings. The audible signal
source is also the recording source available
on the outputs RECORD [51], TAPE 1[50], and
TAPE 2 [49].
Note:
The outputs TAPE 1 [45] and TAPE 2 [44] are
mutually interlocked.
If TAPE 1is defined as the signal source, the re-
cord output TAPE 1 [50] is disabled in order to
prevent feedback. However, the signal can be
recorded via TAPE 2.
RECSIN [23]
= , a When you press REC-OUT [19] the content of
REC-OUT [19] TH: TUE R mel: the display [15] changes immediately.
The word IN: is followed by the currently aud-
ible signal source (e. g. TUNER). Seabees
4c TRIE Be BE ERR output a signal source can now be selecte
TMS TUNER REC PROBE following REC: (e.g. PHONO). As a result you
will hear the signal source TUNER via the out-
puts SPEAKERS A [54], SPEAKERS B [55],
PRE-AMP [53], and MONITOR [48], while the
PHONO signal can be recorded via the out-
puts TAPE 1 [50], TAPE 2 [49], and RECORD
[51].
13