Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Start-up
Connecting the outputs, power-on
pe
=
To)
oncoee0
| bd
=
Sz
Ca
common
°
o fol
Q
ee
ee
Speakers
Active speakers
MONITOR [48]
Power Amplifier
Two speaker pairs can be connected to the
goldplated speaker terminals SPEAKERS
A
[54] and SPEAKERS
B [55] of the REVOX
B250 - amplifier.
Speakers with an impedance of 4 Ohm or 8
Ohm should preferably be used.
Connect only the terminals of like color be-
tween the amplifier and the speakers (correct
phasing).
The ground terminals (black terminals) of the
individual speakers must not be interconnect-
ed.
In order to minimize power loss to the speak-
ers. Use cables with a large conductor cross-
section. 12 gauge wire can be easily connect-
ed to the terminals. Conventional banana plug
(diam.4mm) can be connected directly.
Active
speakers
(with
built-in
amplifiers)
should be connected to the PRE-AMP [53]
output of the preamplifier.
This output is activated when you press the
PRE-OUT [34] key (behind the hinged cover).
When connecting active speakers, limit the
maximum cable length to the value recom-
mended in the relevant operating instructions
and use only well-shielded audio cables.
The outputs TAPE 1 [50] and TAPE 2 [49] are
reserved for the recording paths of the record-
ers TAPE 1 and TAPE 2. When a tape recorder
operates in play mode, the record output of
the corresponding
unit is disabled so that
TAPE COPY from one recorder to another is
possible without feedback.
An additional tape recorder or an additional
amplifier can be connected to the MONITOR
[48] output. These units will not be affected by
the volume, tone, and balance controls.
This output always carries the signal from the
source that is also audible via the amplifier
outputs (SPEAKERS A/B, PREAMP).
Werbung
