Studer Revox B250-S Bedienungsanleitung Seite 40

Start-up
Checking the line voltage,
connecting the signal source
REVOX:
somes C1 | LI
moaoeDea
aoomod
QO
Checking the line voltage
Connecting the signal sources
Tuner, CD, Aux
esses! _—i[s"sesl
CD-Player
Turntable
Tape recorders
Cc 1 COO
oe | [am
T |
Tape 1 L
Make sure thatthe voltage rating inscribed be-
low the power inlet [56] agrees with your local
line voltage.
The amplifier can be switched to a different
line voltage but this work should be per-
formed by your dealer.
Make sure that all components to be connect-
ed to the amplifier are switched off, or even
better, disconnected from the AC power
source.
Connect the audio outputs (OUTPUT) of these
components (signal sources) such as tuner,
CD player, and tape deck to the correspond-
ing inputs of the amplifier.
An additional CD player, a third tape recorder,
or a second tuner can be connected to the au-
xiliary input AUX [43].
Do not confuse the channels left (L) and right
(R).
Connect the outputs of a tuner (radio receiver)
ae player to the inputs TUNER [46] or CD
[42].
Connect the turntable outputs to the corre-
sponding PHONO [38/40] inputs of your am-
plifier.
lf your turntable is equipped with a stranded
ground wire, the latter should be connected to
the ground terminal [39].
Turntables with a conventional moving mag-
net cartridge system should be connected to
the terminal marked MM [40] while those with
amoving coil cartridge system should be con-
nected to the terminal marked MC [38]. If an
MC cartridge system is used the amplifier
must be retrofitted with an MC preamplifier
(option).
Two tape recorders can be connected to the
amplifier. Connect the tape recorder outputs
to the TAPE 1 [45] and TAPE 2 [44] inputs of
the amplifier.
For making recordings, the tape recorder in-
puts must be connected to the corresponding
amplifier outputs TAPE 1 [50] and TAPE 2 [49].