Fig. 21: Tensioning the frame
Fig. 22: Clamp the frame finally
Mounting the frame in the door or window cut-out
Make a ¼ turn with the tension lever clock-
•
wise.
The tension lever is now firmly seated.
•
Proceed in the same way for all 4 tension
levers.
Then check the fit of the frame in the cut-out
•
and correct if necessary.
Then tighten the frame firmly. To do this, turn
•
the 4 tensioning levers clockwise, one after
the other so that a detent tooth of the detent
disc engages on the threaded pin.
EN
9