Wohler BC 600 Bedienungsanleitung Seite 20

Mounting the frame in the door or window cut-out
4.2 Inserting the
frame into the
door or window
cut-out
Fig. 19: Fitting the frame into the door
cut-out
Fig. 20: Clamping lever pushed against
grub screw
1
4
5
2
3
NOTE!
For installation, a straight area of 5 mm width is
required along the frame in the door or window
cut-out so that the additional frame can be sealed
airtight.
Place the frame in the door or window cut-out.
•
Pull it apart until the frame rests against the
•
cut-out.
To clamp the frame in the cut-out, proceed as
•
follows:
Turn the tension lever (1) anticlockwise until it
•
can be moved in the rail (2).
• Push the tensioning lever against the strut (3)
so that the locking washer (4) rests against
the threaded pin (5), cf. the adjacent illustra-
tion.