Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DOOR STATION START-UP.
Power up the system, using the transformer article PRS210 (not supplied) which requires the presence of the 230 Vac mains sup-
ply. In order for the external door sttion to work, it must be connected to the Internet via network cable (LAN) connected to your
router or v ia W i-Fi network . In order t o proceed w ith t he installation and configuration, as w ell as t o set t he W i-Fi connection
parameters, it is necessary to download and install the IP EVO application available for iOS and Android on your smartphone.
To download IP EVO you can scan the following QR-codes:
CONFIGURATION VIA THE IP EVO APP BY THE INSTALLER
Once the IP EVO application has been downloaded and installed on your mobile device, your smartphone can be used as
a tool for configuring the push-button panel: through which you can set parameters such as connection mode, add users
and the procedure for sending connection invitations. Proceed as indicated in the following steps:
Installer user registration
After installation of the app, the first step is to register the installer user by providing an email address and setting an
access password that meets the indicated security criteria. At this point, a control and verification code is sent to the pre-
viously provided email address, which must be entered in the box provided by the app.
Adding the push-button panel and Internet connection
In order to operate the door station remotely and to be able to invite users to receive the call, it is necessary to link the
door station to your installer account. Log in using the credentials you have just registered. In the Welcome window that
will be displayed, click on the option relating to the start of the installation procedure at the bottom of the page or on the
button relating to the addition of a new installation (in the case of a subsequent addition) and scan the QR code.Scan the
QR code. Choose the connection mode of the door stationand if necessary you will be asked for the parameters for the
internet connection (wifi password for example).
Users management
In order to be able to make intercom calls to users, it is necessary to create housing units (flats) and invite users who
will be enabled to receive calls.During creation of the apartment unit, you will be asked for an alias, i.e. the code to be
entered into the push-button panel to call the apartment unit, and the name if you want it to appear in the directory on
the push-button panel display.
Once the housing unit has been created, users can be invited by entering an email to which they will receive the invitation
(See section "Accepting the invitation").
Push-button panel management
In the device settings section it is possible to configure the outputs controlled by the push-button panel (S+/S- and the
relay) and the codes for operating the outputs via the keypad (passcodes).
INSTALLER
iOS
Android
Mi 2587
- 7 -
Werbung
