Telemotive AG blue PiraT2 Bedienungsanleitung Seite 19

blue PiraT2 Release Notes
Firmware/Client V1.8.1, Datum: 25.06.2013
4855 Wrong CAN channel for
complex triggers
4955 The missing of CAN ACK
messages is not
apparent
5061 Checksum problem with
MOST150.MEP
5096 Client Lib shows no error
message when reading a
blue PiraT1 offline
dataset.
5112 Client crash during
firmware update from
network directory
5129 Datalogger does not
enter sleep mode
5143 No download and
conversion of corrupted
data blocks
5146 [PreReleases 1.8.1 only]
Ethernet connector
without function
5163 Device buttons without
function
5181 Datalogger shuts down
during high busload.
5197 Incorrect MOST25
conversion to OP2 file
5207 RTC component failed,
date and time jumps to
1999-12-31
5216 Poor download and
conversion performance.
5247 [PreReleases 1.8.1 only]
No startup in spite of
MOST25 traffic
Copyright Telemotive AG, alle Rechte vorbehalten.
The setting of CAN channel
number for complex triggers
always sets itself back to channel
1.
The missing of CAN ACK
messages is not apparent after
conversion into some formats.
The check sequence Bit order for
recorded MOST150.MEP data is
wrong.
Client Lib shows no error
message, if the function
"initOffline()" leads to "blue PiraT
1" offline data.
A manual input of network drive
for firmware update leads to client
crash. The bug was fixed. An
error message was implemented.
The Datalogger does not enter
sleep mode, although all CAN
channels are inactive overnight.
Currently the client does not
consider corrupted data blocks.
These data blocks result from
disconnecting the logger from
power supply during logging
process. This can lead to data
loss of more than 60 seconds.
An Ethernet controller
configuration problem caused a
malfunction of the Ethernet
connector (front side).
No function of buttons after very
slowly voltage supply increasing
(0,1V/second at 6V).
The datalogger suddenly shuts
down on high busload.
MOST25 control channel data are
converted incorrectly to OP2
format.
If the voltage at the logger fell
below a value of 5V, no clean
reset was performed by the
logger. This could lead to time
jumps.
"Download an conversion of
many formats are running with
poor performance. The
performance was increased. "
No automatic startup after
manual shutdown ("Esc" button)
although MOST25 traffic.
[Ticket = '2013010885000032']
[Ticket = '2012112785000033']
[Ticket = '2013011485000057']
[Ticket = '201212198500002']
[Ticket = '2013010985000076']
[Ticket = '2013012885000085']
Seite 19 von 22