Telemotive AG blue PiraT2 Bedienungsanleitung Seite 18

4466 MOST150/25: Logger
wakes up though the
wakeup is deactivated
4467 Sporadically the sorted
download fails due to
corrupted data
4493 [PreReleases 1.8.1 only]
Clean up the temporary
files.
4527 [PreReleases 1.8.1 only]
Wrong displaying on
Remote Control.
4540 Option "Delete selected
data" is active
4551 Corrupted installation file
downloaded from the
data logger
4613 Compressed data
download abortion
4771 MOST SpyNIC startup is
not specification
compliant
4788 [PreReleases 1.8.1 only]
The Bus-Spec FlexRay
configuration caused an
unclear error message
4789 Wrong additional
FlexRay messages
4809 Impossible Logger
access caused by wrong
Ethernet settings
Seite 18 von 22
blue PiraT2 Release Notes
Firmware/Client V1.8.1, Datum: 25.06.2013
Though the wakeup configuration
was deactivated, the logger woke
up due to traffic on the MOST
ring.
In certain cases the sorted
download failed. Reason was
corrupted data, which was
induced by hard power off.
The client saves temporary files
in directories not provided for this
purpose. These data remain. The
error has been resolved.
The Remote Control displays the
sign "°C" only as "C". The bug
was fixed.
The option "Delete selected data"
was set active by default. This
option is now inactive.
By using some browsers, the
installation file is corrupt, after
download from the data logger.
The client installation is
impossible. The Microsoft
Windows-Update KB2790655
repaired the problem.
Storage space calculation is
always done uncompressed. The
download is cancelled, although
the space would be enough. The
compression depends on the
data. Pre-calculation is
impossible. A note has been
added. The user can still continue
the download.
MOST SpyNIC startup is not
specification compliant. The reset
after startup is missing.
Unclear error message, if the
concrete number within Client
configured Flexray Channels
differs to the Bus-Spec. The error
message was improved.
Caused by EMV modifications,
wrong additional FlexRay
messages are recorded.
Wrong Ethernet settings for
"eth0" (Front), "eth1" (Ethernet
Kit) or "Wi-Fi" inhibits data logger
access. A wrong setting is not
longer taken over and is shown
as Error (red LED). A specific
error message is implemented.
Copyright Telemotive AG, alle Rechte vorbehalten.
[Ticket = '2013012885000058']
[Ticket = '2013020785000051']