Telemotive AG blue PiraT2 Bedienungsanleitung Seite 15

blue PiraT2 Release Notes
Firmware/Client V1.8.1, Datum: 25.06.2013
3901 Cancel a conversion
3933 Default setting for digital
outputs
4039 Firmware Downgrade
4068 Timeout extension for
Remote Control
4078 Support extended CAN
IDs less than or equal to
11 bit.
4247 Telemotive ASCII format
extension MOST Light
on/off
4327 Conversion of self
compressed files
4389 Supporting XTMT format
4390 Improvement of the
firmware download view
within the webbrowser
4688 Virtual Ethernet interface
expansion
4691 Keep Awake option for
Ethernet logging
4766 Configurable CAN event
for Trigger
4784 Bug report automatically
includes the serial
number
4826 Better informations for
incompatible
configurations
4992 Support DLT
VerboseMode (subject to
licence)
Copyright Telemotive AG, alle Rechte vorbehalten.
A running conversion can now be
aborted.
The default values for digital
outputs are now configurable via
the Client.
Under certain preconditions, a
firmware downgrade is now
possible.
Instead of the last message, the
remote control will now show
after 10 seconds "---".
The data logger now supports
extended CAN IDs that are less
than or equal to 11 Bit.
The general MOST state byte
"light on/off" is now implemented
within the Telemotive ASCII
format.
Self compressed offline data sets
(in .zip format) can now be
converted by the Client.
The Telemotive XTMT format is
now supported as output format
for conversion.
On the html page to download the
client software from the data
logger the needed version of the
JRE "java runtime environment"
is added. Additionally to stress
the download link, the text "blue
PiraT Client Download" was
underlined.
Four more configurable virtual
Ethernetports were implemented.
The option "keep awake" is now
available for the Ethernet logging
interfaces.
The user can now define CAN
signals manually by DBC file, to
initiate a Trigger.
The serial number is now
automatically copied into the bug
report.
Does the configuration not fit to
the logger, the user is not
informed sufficiently. This was
improved. Now it is clearer, if a
configuration fits or must be
converted.
The DLT VerbosMode will
supported now for Ethernet. It
can be configured by using the
client or BusSpec.
To use this functionality a suitable
licence is necessary.
Seite 15 von 22