Telemotive AG blue PiraT2 Bedienungsanleitung Seite 17

blue PiraT2 Release Notes
Firmware/Client V1.8.1, Datum: 25.06.2013
3624 Deactivated channels
could wake up or keep
awake the data logger
3701 [PreReleases 1.8.1 only]
Datalogger not
connected.
3838 Analog recording starts
only after 3 seconds
3967 CF card and USB Stick is
not detected.
4043 [PreReleases 1.8.1 only]
Bugreport with Tracedata
impossible.
4110 Analog IN channels #3 to
#10 provides too few
measurement values
4198 CAN messages without
acknowledge are not
handled correctly
4356 buslist cannot be read on
a PC with 64bit
processor and Windows
7.
4371 Datalogger crashes when
formatting CF card
4388 Download settings are
not intuitive
4405 Copy and Paste does not
work for channel names.
4427 Deviation too big for
analog inputs 3 to 10
4437 Though closing the
configuration window the
logger is still allocated.
Copyright Telemotive AG, alle Rechte vorbehalten.
Though a channel was
deactivated, it could wake up or
the data logger .
The data logger sporadically
loses the network connection to
the client.
The analog data recording starts
3 seconds after Datalogger
startup.
If a CF card or USB stick
disconnected without "Safely
Remove", a new connected
device is not detected. A new
Errormessage was implemented.
A creation of bugreport with trace
data is impossible.
The analog IN channels provides
fewer measurement values as
specified.
Currently CAN messages without
achnowledge are not handled
correctly by the logger. The
information about the missing
acknowledges is not logged,
which leads to further conversion
errors (e.g. for CANoe ASCII).
On a system with 64bit processor
and Windows 7 the BMW buslist
cannot be read.
The datalogger crashes during
formatting of CF card. The bug
was fixed.
The default settings for data
downloads are not intuitive to
find. There are now significant
improvements.
The standard function "Copy and
Paste" does not work for channel
names.
The measured values differed
sporadically for 2.5% of the real
voltage. This bug was fixed, the
deviation is below 1%.
If the configuration tab was
closed during loading of the
configuration, the logger ass still
alllocated and did not change to
sleep mode.
Additionally the remote control
does not show the error state.
Seite 17 von 22