Troubleshooting; Installation; Safety; General Safety Instructions - STIEBEL ELTRON EBK 5 K Bedienungsanleitung

OPERATION | INSTALLATION

Troubleshooting

6. Troubleshooting
Problem Cause
The appliance does not The appliance is not
heat up. plugged into the mains.
The appliance is not
switched on.
The fuse/MCB has blown/
responded.
There is no water in the
appliance.
The appliance switches The appliance is scaled
off before it reaches boil- up.
ing point.
The hot water flow is The appliance is scaled
significantly reduced, de- or dirty.
spite the draw-off valve
being fully open.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your request, provide the number from
the type plate (000000-0000-000000).
www.stiebel-eltron.com
Remedy
Insert the plug into the
mains socket.
Switch the appliance on.
Check the fuse/MCB in
your fuse box/distribu-
tion panel.
Fill the appliance with
water.
Descale the appliance.
Clean and descale the
appliance.
Typ: EBK 5 K
Nr.: 000000 0000 000000
- -
5l K 0 MPa 10l/min
2kW 230V 50Hz 8,7A
Made in Germany

INSTALLATION

7.

Safety

Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1

General safety instructions

We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
7.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
8.

Appliance description

The appliance heats DHW electrically. Once the selected temper-
ature has been reached, the temperature limiter switches the
appliance off.
8.1

Standard delivery

The following are delivered with the appliance:
- Fill/drain tap
- Wall mounting bracket
- Two screws, two rawl plugs, two washers
- Installation template
8.2

Accessories

Replacement drain taps, replacement pivoting spouts and drain
outlets with stench traps are available as accessories.
9.

Preparations

9.1

Installation site

Always install the appliance vertically (oversink) in a frost-proof
room.
10. Installation

10.1 Appliance installation

See also chapter "Alternative installation methods".
EBK | KBA | 19