Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3
Installation and user guide
The following steps will help you get up and running with your new Ei salt water chlorinator.
!
WARNING!
The installation and use of Ei salt water chlorinators must comply with the instructions and
recommendations presented in this manual. For additional information, please contact your
professional pool retailer.
3.1 Installing the Ei power pack
1. Find a suitable location for the power pack mount. It should be installed no further than 1.8 metres
from the cell (this is the maximum cell cable length), ideally in the technical shed with the fi ltering
system or next to the fi ltering unit.
IMPORTANT: If the power pack is mounted on a post, a waterproof panel (at least 300 mm by 400
mm high) must be fi tted behind the power pack.
2. Using the screws provided fasten the mount solidly to the wall and place the power pack on it.
NOTE: Only connect the appliance to a power outlet once the installation has been completed (See
the Connection to Ei power pack paragraph).
22
Werbung
