monzana MZPP05 Bedienungsanleitung Seite 17

Filter medium
O-ring
2-in-1 hose adapter valve,
diameter 32 mm / 38 mm
Cover
Manometer
PLACEMENT OF THE UNIT
Note: The pump is not self-priming.
Place the sand filter system (empty of filter media) close to the pool. Important: The system must
be located far enough from the pool so that splash water cannot damage the pump or cause
flooding.
Installation and set-up must be performed in accordance with local regulations, according to the
rules of your pool and the local conditions.
The system must also be placed on a secure, stable surface. The filled tank will be very heavy and
must not tip over, e.g. due to collapsing ground, nor cause any damage to your floor.
Take into account the connections to be made later, e.g. water and pump power, when positioning
the filter.
Ensure that the instruction label is still visible on the tank and pump in case any questions or issues
arise later.
Instructions
• Ensure that the filter works under pressure and that the pump can provide sufficient power.
• If the pump is placed above the water level, a backflow valve must be installed in the system
(please refer to the instructions for the pump in question).
• If the pump is positioned below the water level, it is important for maintenance purposes to
ensure that the water supply to the pump is interrupted, otherwise the water may run out of
the pool unhindered.
• Hoses and connections should be kept as short as possible and without any kinks. This reduces
the flow capacity, meaning your system would suffer unnecessary loss of performance.
• Make sure that the connection rings, hose clamps and all sealing rings are properly positioned.
• Never over-tighten the screws of the hose clamps and the neck of the tank. This would damage
them and cause the system to lose pressure.
CONSTRUCTION (graphic on page 3)
Note: You can also fill the tank with filter sand or filter glass instead of the included filter balls.
1. Before using the valve (2), the lever (1) must be attached to the valve: Place the lever on the
valve and secure it by pushing the supplied metal pin through the two holes in the lever. Use
a screwdriver and a rubber mallet to disengage the lever from the valve again and carefully
knock the metal pin out of the opening.
2. Mount the drainage nozzle (6) on the filter tank (7) as shown, making sure that the seals are
in the correct position (Fig. 2).
NO. STK
11 1
12 3
13 3
14 1
15 1
17
PVC hose
Hose clamp 21-44 mm
2-in-1 hose adapter
pump, diameter 32 mm /
38 mm
Teflon band (without
image)
NO. STK
16 1
17 2
18 2
19 1
www.DEUBAXXL.de