HomeMatic IP HmIP-SMI Montage- Und Bedienungsanleitung Seite 37

You can manually start the pairing mode for an-
other 3 minutes by pressing the system button (B)
shortly (see figure 5).
• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
• Please wait until pairing is completed.
• If teaching-in was successful, the device LED (B)
lights up green. The device is now ready for use.
If the device LED (B) lights up red, please try
again.
After the pairing procedure has been finished, the
function test of the motion detector starts (see „7
Function test" on page 38).
• Select the desired solution for your device.
• In the app, allocate the device to a room and give
the device a name.
Start-up
37