Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Insert the plugs into the bore holes.
•
Place the wall mounting bracket and turn the
screws into the plug.
•
Only insert the motion detector into the wall
mounting bracket after the device has been put
into operation (see sec. „6 Start-up" on page
36).
5.1.2
Adhesive strip mounting
For the installation with adhesive strips, please proceed
as follows:
•
Choose a site for installation.
•
Depending on the installation site - wall or corner
- fix the adhesive stripes to the middle or on the
side of the wall mounting bracket (E).
•
Remove the protective film and press the wall
mounting bracket (E) to the desired location.
Make sure that the mounting surface is smooth,
solid, non-disturbed, free of dust, grease and sol-
vents to ensure long-time adherence.
Mounting
35
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
