Restore Factory Settings - HomeMatic IP HmIP-SMI Montage- Und Bedienungsanleitung

Restore factory settings

10 Restore factory settings
The factory settings of the device can be re-
stored. If you do this, you will lose all your set-
tings.
To restore the factory settings of the motion detector,
please proceed as follows:
• Open the battery compartment (C) on the rear
by pushing the battery compartment cover (D)
down or by removing it from the wall mounting
bracket (E) (see fig. 4).
• Remove the batteries.
• Insert the batteries ensuring that the polarity is
correct (see figure 6) while pressing and holding
down the system button (B) for 4s at the same
time, until the LED (B) will quickly start flashing
orange (see figure 5).
• Release the system button again.
• Press and hold down the system button again for
4s (see figure 5), until the device LED lights up
green.
• Release the system button to finish the proce-
dure.
The device will perform a restart.
44