CENTROPIX KLOUD+ Bedienungsanleitung Seite 31

27
15. Disposal
This CENTROPIX product, including all parts contained therein
(e.B cables, wires, etc.), comply with the requirements of Directive
2011/65/EU on the restriction of the use of certain hazardous
substances in electrical and electronic equipment (RoHS).
When disposing of the appliances or batteries, observe local
regulations. Batteries do not belong in the household waste and
must not be thrown into the open fire, otherwise there is a risk of
explosion. Be sure to ensure that the batteries are disposed of
properly.
If you need further information, please contact your advisor.
16. Troubleshooting
In case of an error message or suspected malfunction, check the following points first. Errors are generally indicated by acoustic beeps
and two flashing LEDs.
ERROR POSSIBLE CAUSE
No L.E.D.s lighting up after 15 seconds Battery empty
boottime (after turn on power).
Power L.E.D. and indicator L.E.D. flash • Computer error
• The cable connection in the device
and a signal tone sounds.
interrupted
After connecting to the app (blue L.E.D. Bluetooth connection error between app
on) the L.E.D. flashes and the connection
and KLOUD .
is interrupted.
(Message in the CENTROPIX-
App).
Requested program not available Program is expired.
(custom programs). Program not booked.
The device is switched on but does not
start the program.
The green «OK-LED» flashes. Contact defect in the applicator.
If an error cannot be corrected or can be specifically located, please proceed as described in the chapter „Repairs".
REMEDY
Charge battery with charging cable.
Switching off and on again.
Press the Connect button again, if
necessary, confirm the new connection
on the smartphone/tablet.
Book the desired program (again) (via App)
or use one of the 5 pre-installed programs.
Establish a connection between
applicator(s), update starts automatically.
Device must be sent to CENTROPIX.
28