Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8. Initial Set-Up
1
2
Remove the KLOUD
devices
Before using the applicator for the
first time, charge the batteries. To
from the design box and place them
do this, connect the power supply
on a flat surface.
unit to the respective applicator with
the USB cable (see chapter Batte-
ry). Make sure that you first click the
power plug that corresponds to the
power supply in your country into
the adapter. You can use the other
adapter in other countries, e.g. when
travelling.
The power supply unit and plug must
be in undamaged original condition.
Contact CENTROPIX for replacement
of damaged parts immediately!
Info: When removing the magnetic
charging cable, the dongle can come
off. Disconnect the dongle from the
charging cable and plug it back into
the socket.
09
3
The charging time is approx. 4 hours.
The battery is full when the blue L.E.D,
the charging symbol goes out at the
battery, and the green L.E.D. on the
charging cable lights up.
Press the «Power» button above the
keyboard. The «Power» L.E.D. Lights
up immediately.
After approx. 15 seconds the device is
ready for operation and the «Ready»
LED
lights up. The blue LED
and
the green P1 LED
light up.
Powered by
Powered by
Powered by
9. Control Unit
On and off button
Program selection
button
Program Start / Stop
button
App connection
button
Blue LED is on:
Connected via Bluetooth
TIP:
How to use the LEDs and
the deactivate sound signals
Red LED lights up or flashes:
can be found under the menu
Battery almost empty
item «application».
Connection for charging
cable (magnetic)
Ventilation slots
Program & intensity display
Custom program: additionally
selectable via the app
Blue LED lights up:
Device is switched on
Green LED lights up:
Device is ready for
operation
When charging:
Blue LEDs on (device & charging cable) = battery is charging
Blue LED on device is off and green LED on charging cable is on =
battery fully charged
10
Werbung
