Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12. SCAN-X
With the SCAN-X module, you can display
the electromagnetic field by means of an
acoustic signal and is therefore suitable
as an effective demonstration for those
interested.
To do this, switch on the Scan Module
Changing the battery
by pressing the button, keep it pressed
and hold it in the area to be tested
of the SCAN-X
(L.E.D. lights up).
The more intensive the signal to be
Open up the SCAN-X Case by
measured, the louder the sound of the
pushing apart the upper and lower
SCAN-X.
case (i.e. by using a screwdriver).
Replace the CR-2032 battery with
It is best to use the program P3:
a new model.
«Energization».
If the battery is low, the red L.E.D. is only
displayed during the first 2 seconds.
Suppose the battery capacity is less than
10%, the red L.E.D. lights up.
Suppose the battery capacity is less than
5%, the red L.E.D. flashes.
23
13. Battery
Do not use the KLOUD
while it is
charging. Both KLOUD
applicators
are
equipped
with
a
high-quality
lithium-ion battery. A new, fully charged
battery lasts for over 4 hours of use or ap-
prox. 17 applications of 15 minutes each.
Depending on the battery care or age of
the battery, the number of applications
per battery charge may be lower.
Check battery status
Press the program selection button
for
3 seconds. Depending on the battery
status, the LEDs P1 to P5 light up (example:
Powered by
All LEDs from P1 to P5 light up means
that the battery is full).
100 %
75 %
50 %
25 %
10 %
0 %
The charging time is about 4 hours.
The 1.8 m long charging cable and the
During the charging process, the charging
magnetic connections of the KLOUD
L.E.D. «Charging battery» is lit.
maxi and the KLOUD
convenient
charging.
Exception: If the battery is very low, it
charging cable to the applicator and
can take one to two minutes to start the
the green L.E.D. on the charging
device, then the blue power L.E.D. Lights
cable changes to blue. If the L.E.D.
up, but the system cannot start. in this
does not change to blue, the battery
case, please connect the charging cable.
is already fully charged. In addition,
the blue charging L.E.D.
As soon as the battery is charged, the
applicator keyboard lights up during the
charging process is automatically termin-
Powered by
charging process.
ated and the blue charging L.E.D. goes
out.
Fold the KLOUD and open the leather
When the battery status is approx.
flap on the side of the headboard. Fold
20%, the L.E.D. «Low battery» lights up.
the flap underneath and carefully pull out
Then approx. 2 more therapies can be
the white plug. Disconnect it by pres-
performed. At a battery level of approx.
sing the release clip. Pull out the battery
10%, this L.E.D. starts flashing. You can
which is the short part of the plug.
then perform approx. 1 therapy before
the battery needs to be recharged.
Insert the new battery and reconnect the
cable. Reposition the white plug as before
mini ensure
and close the leather flaps.
Connect
the
Only the original battery and the supplied detachable
on the
power supply unit with the original charging cable
may be used. If another battery or charging cable is
used, the device can be damaged, e.g., the warranty
becomes void.
Replacement batteries or charging cables can be
ordered through your CENTROPIX consultant or
online on the CENTROPIX Partner Page.
24
Werbung
