Scheppach ELS1800 Originalbetriebsanleitung Seite 18

1. Introduction
Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
we hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities in
accordance with the recommendations. The operat-
ing instructions contain important information on how
to operate the machine safely, professionally and
economically, how to avoid danger, costly repairs, re-
duce downtimes and how to increase reliability and
service life of the machine.
In addition to the safety regulations in the operat-
ing instructions, you have to meet the applicable
regulations that apply for the operation of the ma-
chine in your country. Keep the operating instruc-
tions package with the machine at all times and
store it in a plastic cover to protect it from dirt and
moisture. Read the instruction manual each time
before operating the machine and carefully follow
its information. The machine can only be operat-
ed by persons who were instructed concerning the
operation of the machine and who are informed
about the associated dangers. The minimum age
requirement must be complied with. In addition to
the safety instructions in this operating manual and
the separate regulations of your country, the gen-
erally recognised technical rules relating to the op-
eration of identical devices must also be observed.
18 | GB
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (Fig 1-2)
1. Shift lever
2. Safety switch
3. Upper push bar
4. Mains connection/mains cable
5. Tensioning lever
6. Middle push bar
7. Catch basket
8. Lower push bar
9. Handle height adjustment
10. Working height adjustment
11. Rear wheel
12. Front wheel
A. Allen key size 5
B. Cable strain relief
C. Cable clamp
D. Brush
3. Unpacking
• Open the packaging and remove the device carefully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, store the packaging until the warranty
period has expired.
m ATTENTION!
The device and packaging materials are not toys!
Children must not be allowed to play with plas-
tic bags, film and small parts! There is a risk of
swallowing and suffocation!
4. Intended use
• The machine is designed and built according to the
state-of-the-art and the safety-related standards.
Nevertheless, the use of the machine might involve
risks such as personal injury, danger to life for the
user or third parties, or damage to the machine and
other material property.
• The machine is to be used only in a technically
flawless condition as well as in accordance with
the manufacturer's instructions and in a safety and
risk-conscious manner while adhering to the oper-
ating instructions! In particular, failures which may
impair the safety must be resolved immediately (by
you or an expert)!
• Sweeping of flat and dry surfaces – e.g. entries,
terraces, courtyards, etc.
www.scheppach.com