Toro Revolution 60V Bedienungsanleitung Seite 12

Using the Backpack
WARNING
Improper use of the backpack, backpack
tether, or an attached tool can create risk of
injury.
Read and follow the Operator's Manuals for
the backpack and your specific tool before
using the backpack tether with the backpack.
1. Connect your tool to the backpack; refer to the
Operator's Manual for your tool.
Note:
Refer to the Operator's Manual for the
backpack tether.
2. Ensure that the vent on the bottom of the
backpack is clear of any dust and debris
11).
1. Backpack vent
3. Set the backpack down on a level surface.
4. Pull up on the latch tabs to open the latches
securing the battery cover and set the cover
aside.
5. Line up the cavity on the back of the battery with
either of the battery ports in the backpack.
6. Slide the battery pack down into the backpack
until the battery pack is fully seated and locked
into place (Figure
Figure 11
12).
(Figure
1. Battery cover
2. Battery cover latches
g378372
7. Place the battery cover onto the backpack and
secure it using both cover latches.
8. Put on the backpack and secure the shoulder
straps; refer to
(page
9. Operate the attached tool; refer to the Operator's
Manual for your tool.
10. Always remove the backpack tether from the tool
and/or remove the batteries from the backpack
whenever you are not using the tool.
10
Figure 12
3. Battery troubleshooting
lights
Adjusting the Backpack Position
8).
g379460
g379461