Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Ordinary recording
To tape record FM and AM broadcasts, make the recording
from
connections
made
to the
recording
("REC
OUT'')
terminals
of the amplifier,
in the same
way
as for record-
ing of other program
sources.
Connections
should
be made
between
the output (''OUT-
PUT')
terminals
of this
unit
and
the
tuner
(''TUNER"')
terminals
of the
amplifier,
and
from
the tape
deck
to the
tape deck terminals
(''TAPE DECK'') of the amplifier.
[
|
terminals
("OUTPUT"')
Tuner terminais
("TUNER")
oye UUNNDNUNEAUADNUMI 2
WU
tom
Playback
terminals
("PLAYBACK")
terminals
('REC OUT"')
Input terminals
("LINE IN'')
Mi Recording
@ Set the input selector of the amplifier to the ''tuner''
position.
@ Push
the
'rec
ievel
check''
selector
pushbutton®
of
this unit (—— m).
@ As a result of steps@
and @ above,
a signa! of about
440
Hz
wili
be
emitted
from
the
output
(""OUTPUT'')
terminals
of this unit and through the recording
('REC
OUT")
terminals
of the amplifier. Watching
the meters
of the tape deck,
use either the output level contro!®
of
this unit or the input level control
of the tape deck to
adjust the recording
level.
- For a cassette tape deck, make the adjustment so that
the indication needles
indicate about
—2 dB.
- For an open-reel tape deck, make the adjustment so
that the indication needles
indicate about 0 dB.
* Note that the optimum recording level value may vary
depending upon the program source and the tape deck
itself. Determine
the correct
recording
level
in con-
sideration of all conditions.
© Push the ''FM"
or "AM" selector
pushbutton@
(f— m),
tune to the
broadcast
to be
recorded,
and
begin
the
recording.
To record directly from this unit
Connect the recording
(''REC OUT") terminals
of this unit
to the input ("LINE IN') terminals of the tape deck.
Recording
terminals
("REC OUT')
Input terminals
("LINE IN")
Tape deck
The output level contro!@®
has no effect upon the signals
from the recording ('REC OUT'') terminals of this unit; the
signals are always at a constant level. The recording level,
therefore,
can
only be adjusted
by using the input level
control of the tape deck.
Other
steps
are
the
same
as
described
in the
section
"ordinary
recording " above.
Werbung
