Werbung
Verfügbare Sprachen
Verfügbare Sprachen
F it t in g In s t r u c t io n s
AC Schnitzer Front Splitter - 2
Fitting ....
Remove the AC Schnitzer front splitter again.
Fig. 28
Drill out all Ø 6mm holes with a Ø 11mm drill bit.
Fig. 29
Mitgelieferter M6 Hohlraumanker in die Bohrungen ein-
setzen. Mit dem mitgelieferten Fixierwerkzeug des
Hohlraumankers und einer Sechskantschraube
M6x20mm den Hohlraumanker vorsichtig festziehen.
....to do this
Fig. 30 & 31
WARNING!
When inserting the M6 cavity fitting, proceed with
particular care.
Use supplied hexagon head screw M6x20mm into the
cavity fitting M6 and counterhold the cavity fitting M6
with the fixing tool. By screwing in the hexagon head
screw, the cavity fitting M6 is compressed axially and
spreads all 4 wings radially on the back of the beam.
Do not tighten the M6 cavity fitting in one step.
Tighten the M6 cavity fitting "step by step"!
AC Schnitzer - automobile Technik - Neuenhofstraße 160 - D - 52078 Aachen - Tel. 0241/5688 -130
(G42) M-aerodynamic -
series
Fitting Instructions No: 5111 342 310 / Issue: 29.08.2022 / TSch
32
Werbung
