Fein 9 01 04 003 01 1 Bedienungsanleitung Seite 10

3 41 01 044 06 5 - Buch Seite 10 Dienstag, 2. September 2003 8:13 08
EN
Handling.
Only FEIN magazine screwdrivers with a
spindle collar diameter of 33 mm are suit-
able for driving the magazine holder.
Insert a special screwdriver bit (1) into
the tool holder of the screwdriver.
Push the magazine holder onto the
screwdriver bit and position it as far as
the stop on the spindle collar of the
drive machine.
Inserting the screw strip (5).
Push the screw strip (5) through the
screw strip guide (b).
Guide the screw strip (5) over the
tooth points of the notched discs on
the sliding piece.
Push the screw strip (5) forwards. The
first screw must be positioned in a
groove in front of the centre point of
the screw stop (4).
To remove the screw strip (5) pull it
out upwards.
Setting the magazine holder to the
length of the screw (4).
The magazine holder must be set to the
respective length of the screw.
Turn the grooved knob on the screw
stop until the point of the screw and
inner edge of the screw stop are flush.
Please observe the measuring scale on
the screw stop.
10
Setting the screwdriving depth (3).
The required screwdriving
depth can be obtained by
adjusting the grooved knob (3).
Upwards adjustment:
If the screwdriving depth is greater, the
screw head sinks further into the work
piece.
Downwards adjustment:
If the screwdriving depth is less deep, the
screw head will not sink as far into the
work piece.
The required screwdriving depth will
depend on the material to be treated and
is obtained by trial and error.
Operating instructions.
Before screwdriving work check the
direction of rotation of the drive machine.
The magazine holder may only be oper-
ated in the position "Clockwise rotation".
Always hold the drive machine at right
angles to the work piece.
Switch the drive machine on, lock the
ON/OFF-switch and position the
screw stop (4) on the position to be
fixed.
Using an even pressure, press against
the surface of the work piece until the
screw is inserted. The next screw is
automatically brought into its working
position.
Lift the drive machine from the work
piece.
Any screws that have already been
inserted cannot be taken out again or
tightened using the magazine holder.
9 01 04 003 01 1