Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SWITCHING ON FROM THE REMOTE CONTROL
To switch on, press the "0/I" button;
the welcome message will appear in the control
panel display for a few seconds.
wElCoME To
hYDroSoNiC
36
C
o
rEADY
Display indicating
READY status
There after,
the display goes into READY mode;
the system can now be used
(see Hydrosonic, WhirlpooI or Blower).
To switch off the panel, press the "0/I" a second time:
•
if no cycle has been selected, whether
Hydrosonic, Whirlpool or Blower, the system
shuts off and the display reverts to STAND-BY.
•
if at least one cycle has been selected, whether
Hydrosonic, Whirlpool or Blower, a message
will be displayed prompting DISINFECTION
(see DISINFECTION).
AUTOMATIC SHUTOFF:
If no control panel or remote control button is pressed within 30 minutes following power-up or since
the last function was active (TIMER setting) the system shuts off and the display reverts to STAND-
BY. DISINFECTION of the system is not carried out (see DISINFECTION).
HYDROSONIC - Hydrosilence
20:30
EN
11
Werbung
