Teuco HYDROSONIC Gebrauchsanweisung Seite 14

EN
WHIRLPOOL FUNCTION
While the whirlpool tub is in operation, specific whirlpool tub phytocosmetics may be used. Do not
use soaps, bath oils or products that create foam or are alcohol-based.
STARTING THE WHIRLPOOL
Pressing the "O/I" button to switch on,
the display goes into READY mode.
Start the Whirlpool by pressing the "HYDRO"
button.
The massage starts and the display shows:
• The exact time.
• The temperature of the water in the tub.
• The duration of the whirlpool session
(TIMER) in minutes (adjustable).
• Whirlpool in progress.
When the whirlpool has finished, the system shuts
off and the display reverts to READY.
To cut the session short, press HYDRO a second time; the system shuts off and the display reverts
to READY.
MASSAGE DOES NOT START!!!
If the message "ADD WATER" is displayed, fill the
tub to the level at which the selected massage is
able to start.
14
36 C 20:30
o
rEADY
Display in READY
15 36 C 20:30
o
whirlpool
Display indicating Whirlpool
in progress
36 C 20:30
o
rEADY
Display indicating READY status
ADD
wATEr
Display in DIAGNOSTICS mode
HYDROSONIC - Hydrosilence