Zanussi ZOPKE6K3 Benutzerinformation Seite 42

12.6 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the appliance and wait until it is
cold.
2. Disconnect the appliance from the mains.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate or operate the appliance.
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
The lamp is turned off.
The lamp does not work.
Err C3
Err F102
Err F102
The display shows 00:00.
If the display shows an error code that is
not in this table, turn the house fuse off
and on to restart the appliance. If the
error code recurs contact an Authorised
Service Centre.
42 ENGLISH
3. Place the cloth on the oven floor.
Back lamp
1. Turn the glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
Check if...
The appliance is correctly connected to an electrical
supply.
The automatic switch-off is deactivated.
The appliance door is closed.
The fuse is not blown.
Lock is deactivated.
Moist Fan Baking - is activated.
The lamp is burnt out.
The appliance door is closed or the door lock is not bro‐
ken.
The appliance door is closed.
The door lock is not broken.
There was a power cut. Set the time of day.
13.2 Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on the
front frame of the appliance. It is visible when
you open the door. Do not remove the rating
plate from the appliance.
We recommend that you write the data
here: