Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Problem
Spinning starts late or
the machine does not
spin:
No water is visible in the
drum:
After the check, activate the appliance.
The programme continues from the point
of interruption.
12. TECHNICAL DATA
Dimension
Electrical connection
Level of protection against ingress of solid parti‐
cles and moisture ensured by the protective cov‐
er, except where the low voltage equipment has
no protection against moisture
Water supply pressure Minimum
Water supply
Maximum Load
Energy Efficiency Class
Spin Speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
13. INSTALLATION
WARNING!
Refer to Safety chapters.
Possible cause/Solution
The electronic unbalance detection device has cut in be‐
cause the laundry is not evenly distributed in the drum.
The laundry is redistributed by reverse rotation of the
drum. This may happen several times before the unbal‐
ance disappears and normal spinning can resume. If, af‐
ter 10 minutes, the laundry is still not evenly distributed
in the drum, the machine will not spin. In this case ,redis‐
tribute the load manually and select the spin programme.
• Redistribute the laundry.
The load is too small.
• Add more items, redistribute the load manually and
then select the spinning programme.
Machines based on modern technology operate very
economically using very little water without affecting per‐
formance.
Width/ Height/ Depth/
Total depth
Voltage
Overall power
Fuse
Frequency
Maximum
1)
Cotton
Maximum
If the problem occurs again, contact the
Authorised Service Centre.
495 mm/ 670 mm/ 515 mm/ 550
mm
230 V
1600 W
10 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
3 kg
A
1100 rpm
ENGLISH
21
Werbung
