Toro Flex-Force Power System 60V MAX Bedienungsanleitung Seite 20

Problem
The LED indicator light on
the battery charger is red.
The LED indicator light
on the battery charger is
blinking red.
The tool does not run or
does not run continuously.
Possible Cause
1. The battery charger
and/or battery pack
is over or under
the appropriate
temperature range.
1. There is an error in
the communication
between the battery
pack and the charger.
2. The battery pack is
weak.
1. There is moisture on
the leads of the battery
pack.
2. The battery is not fully
installed into the tool.
18
Corrective Action
1. Unplug the battery
charger and move the
battery charger and
battery pack to a place
where it is dry and the
temperature is between
5°C (41°F) and 40°C
(104°F).
1. Remove the battery
pack from the battery
charger, unplug the
battery charger from
the outlet, and wait
10 seconds. Plug the
battery charger into the
outlet again and place
the battery pack on the
battery charger. If the
LED indicator light on
the battery charger is
still blinking red, repeat
this procedure again.
If the LED indicator
light on the battery
charger is still blinking
red after 2 attempts,
properly dispose of the
battery pack at a battery
recycling facility.
2. Contact your authorized
service dealer or
distributor if the battery
is in warranty, or
properly dispose of
the battery pack at a
battery recycling facility.
1. Allow the battery pack
to dry or wipe it dry.
2. Remove and then
replace the battery into
the tool making sure
that it is fully installed
and latched.