Yamaha QY100 Installationshandbuch Seite 10

Z Start the QY100 Data Filer.
After installation (refer to page 5) and connection (refer to the
"QY100 Owner's Manual") are completed, follow the instructions below to
start up the QY100 Data Filer.
• If you are using Window95/98/NT4.0/2000/Me
Click the "START" button, then click "QY100 Data Filer", which is
located in the "YAMAHA QY100 Data Filer" under the Programs
menu.
• If you are using a Macintosh
Double click the "QY100 Data Filer" icon.
NOTE
• If you use the QY100 Data Filer on a Macintosh System, open the "Chooser" in the
"Apple Menu" and turn off "Apple Talk".
CAUTION
• If the MIDI Driver cannot be used with your computer, the following message will
be displayed.
"The selected MIDI device is in use. Quit any applications using the device."
→ Click "OK", then quit all other MIDI applications (sequencer software, etc.) that
use the MIDI driver, and start the QY100 Data Filer once again.
"Can't find the MIDI device. Confirm the MIDI device settings."
→ The MIDI driver is not properly installed. Refer to page 6/7.
CAUTION
• If the QY100 is not properly connected to your computer, "Data transfer failed.
Confirm QY100 connections (HOST SELECT switch, etc.)" dialog box will be
displayed. Properly connect the QY100, confirm the HOST SELECT switch position,
and start the software again.
Downloaded from:
How to start
the QY100 Data Filer
http://www.usersmanualguide.com/
10