Z-EDGE Z3D Bedienungsanleitung Seite 8

2. Connect the dash cam to the power outlet in your car. (see 2.4)
3. Turn the camera on, whilst looking at the display screen, find a suitable
location for installing your dash cam on your windshield.
1
4. Press the suction mount firmly against your windshield, and rotate the lever
clockwise (12 o'clock) to secure.
5. Use the hand tool provided to tuck the power cable into the headliner.
6. In most cases, the power cable can be tucked behind the rubber trim along the
A-pillar and door frame, use the hand tool provided or gently tug on the
rubber trim to remove it to make room for the power cable. The rubber trim
can be replaced after using the hand tool. In rare cases, it may be necessary to
remove the A-pillar cover.
7. Trace the cable down the side of the door frame to the floor of the vehicle.
Then lift the carpet in the passenger side foot-well and trace the cable beneath this.
8. Alternatively, route the power cable down the door frame and tuck it behind/
below the glove box. Use the cable clips if required.
9. Bring the cable out by the center console to the lighter/auxiliary power socket.
2
-5-