Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
The device can be placed directly on the floor or rigged in any orientation without altering its operational
characteristics.
Mobile use
Unpack the AKKU LED IP FL-20 COB RGB Spot and carry it via the comfortable handle to the desired place
for use.
Place the device on a flat surface, adjust the desired inclination-angle and tighten the fixation screws.
OPERATION
Open the rubber seal of the DC IN-socket on the backside of the device.
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.
Please recharge the AKKU LED IP FL-20 COB RGB Spot indoors only.
The battery pack recharging time for FL-20 is approximately 4.5 hours; when fully charged, the device can
be operated for approximately 4.5 hours.
Please note: The indicator light on the charger indicates the following information.
- The indicator light shows a steady red means the battery pack is being charged.
- The indicator light shows a steady green means the battery pack is fully charged.
Disconnect the charger with connection cable, close the rubber seal of the DC IN-socket, and install the
device as desired (description under INSTALLATION).
Via the on/off push button, you can turn the device on and off. After switching on, the LEDs light up
according to the last control program selected.
Via the enclosed IR remote control, you can adjust the brightness of the static colors as well as the speed of
the internal programs. You can choose from 4 internal programs.
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Remote control
1
The remote control is supplied with battery inserted.
2
An insulating foil between the battery and the battery contacts prevents the battery from being
discharged during storage. Prior to the first operation remove the foil from the battery support on the
rear of the remote control. Otherwise operation of the remote control is not possible.
3
When pressing a button, always hold the remote control in the direction of the sensor. There must be
visual connection between the remote control and the sensor.
4
If the range of the remote control (a maximum of 3 meters) decreases,
replace the battery. For this purpose, on the rear of the remote control press
the small bar with the groove to the right (1) and at the same time remove the
battery support (2).
5
For operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell is facing upwards in the support.
CAUTION! The power unit was designed for indoor use only.
BATTERY DISPOSAL NOTICE
CAUTION!
10/12
00082006.DOC, Version 2.1
Werbung
Inhaltsverzeichnis
