Werbung
Anleitung Inox 1450 WA SPK1
GB
Important notes
G
Attention: Before assembly and starting
operation, read the operating instructions
carefully.
G
Check that the mains voltage corresponds to
the details on the type plate.
G
Only connect to a proper 230 volt, 50 Hz
erthed socket.
G
Minimum fuse protection 10 A,
G
Pull the mains plug out of the socket when:
- the unit is not in use,
- before opening the unit,
- before cleaning and maintenance
G
Never clean with solvents.
G
Do not use the cable to pull the plug out of
the socket.
G
When unit is ready for use, do not leave
unattended.
G
Safeguard from children
G
Care must be taken that the mains
connection lead is not damaged by being
driven over, crushed, stretched, etc.
G
The unit must not be operated if the mains
connection lead is not in perfect condition.
G
Replacement mains connection leads must
not differ from the versions indicated by the
manufacturer
Mains connection cable: H 05 VV - F 2 x 0,75
G
On no account vacuum:
- burning matches, glowing ashes and
cigarette ends, inflammable, corrosive, fire
hazard or explosive substances, vapours and
liquids.
G
This unit is not suitable for vacuuming dust
which is damaging to health.
G
Store the unit in a dry place.
G
Do not operate a defective unit.
G
Servicing only by an authorized after-sales
service point.
G
Use only for operations for which the unit is
intended.
G
Take great care when cleaning stairs.
G
Use only manufacturer's attachments and
spare parts.
6
23.01.2006
14:33 Uhr
Seite 6
Items supplied:
1
Handle
2
ON/OFF switch
3
Head
4
Filter basket
5
Safety float valve
6
Locking hook
7
Tank
8
Hose connector
9
Castors
10 Flexible hose
11 Telescopic vacuum tube
12 Blow connector
13 Dual purpose nozzle
14 Dirt bag
15 Foamed plastic filter
16 Crevice nozzle
17 Handle with air regulator
18 Water drainage screw
Assembly (Fig. 1 - Fig. 13)
Important: Be sure to pull the power plug prior
to assembly!
Fig. 1:
Open locking hook
Fig. 2:
Remove head
Fig. 3:
Remove accessory equipment
Fig. 4:
Connect large wheels to the unit from
below
Fig. 5:
Connect small wheels to the unit from
below
Fig. 6:
Screw wheels tight
Fig. 7:
Secure cable holder hook to unit
Fig. 8:
Screw handle to unit
Fig. 9a: Use the included foamed plastic filter for
wet vacuum cleaning
Fig. 9b: Use the included dirt bag for dry vacuum
cleaning
Fig. 10: Connect head to extractor
Fig. 11: Close locking hook
Fig. 12: Secure suction hose to unit
Fig. 13: Mount required accessory equipment to
suction hose
Werbung
