Items Supplied - EINHELL NTS 1500 Bedienungsanleitung

Anleitung NTS 1500 SPK1
GB
Important notes
Attention: Before assembly and starting
operation, read the operating instructions
carefully.
Check that the mains voltage corresponds to
the details on the type plate.
Only connect to a proper 230 volt, 50 Hz
erthed socket.
Minimum fuse protection 10 A,
Pull the mains plug out of the socket when:
- the unit is not in use,
- before opening the unit,
- before cleaning and maintenance
Never clean with solvents.
Do not use the cable to pull the plug out of
the socket.
When unit is ready for use, do not leave
unattended.
Safeguard from children
Care must be taken that the mains
connection lead is not damaged by being
driven over, crushed, stretched, etc.
The unit must not be operated if the mains
connection lead is not in perfect condition.
Replacement mains connection leads must
not differ from the versions indicated by the
manufacturer
Mains connection cable: H 05 VV - F 2 x 1
mm 2
On no account vacuum:
- burning matches, glowing ashes and
cigarette ends, inflammable, corrosive, fire
hazard or explosive substances, vapours and
liquids.
This unit is not suitable for vacuuming dust
which is damaging to health.
Store the unit in a dry place.
Do not operate a defective unit.
Servicing only by an authorized after-sales
service point.
Use only for operations for which the unit is
intended.
Take great care when cleaning stairs.
Use only manufacturer's attachments and
spare parts.
Keep children and other persons away
from the electric tool while it is being
used. Allowing yourself to get distracted can
cause you to lose control of the tool.
Always pull the plug out of the socket
outlet before making any adjustments.
Exchange accessory parts or put away the
8
09.05.2006 14:58 Uhr Seite 8
tool.
This precaution eliminates the possibility of
inadvertently starting the tool.
When not in use, store electric tools out of
the reach of children. Do not allow those
persons to use this tool who are
unfamiliar with it or who have not read
these instructions.
Electric tools are dangerous when they are
used by inexperienced persons.
If the power cable of the electric tool is
damaged, it must be replaced by a
specially prepared connection lead which
can be obtained from the customer
service center.

Items supplied:

1 Handle
2 ON/OFF switch
3 Head
4 Filter basket
5 Safety float valve
6 Locking hook
7 Tank
8 Hose connector
9 Castors
10 Flexible hose
11 Vacuum tube
12 Blow connector
13 Dual purpose nozzle
14 Dirt bag
15 Foamed plastic filter
16 Crevice nozzle
17 Handle with air regulator
18 Pleated filter
19 Cushion nozzle
20 Automatic cable rewind
21 Storage compartment
Assembly (Fig. 1 - Fig. 13)
Important: Be sure to pull the power plug prior
to assembly!
Fig. 1:
Fig. 2:
Fig. 3:
Fig. 4:
Fig. 5:
Fig. 6:
Open locking hook
Remove head
Remove accessory equipment
Plug the large wheels onto the appliance
from the side
Connect small wheels to the unit from
below
Use the included foamed plastic filter for
wet vacuum cleaning