Product Description; Use And Operation - Klarstein 10031662 Handbuch

1 Temperature Display
2 Temperature Adjust Knob
3 Light Switch
4 Interior Light
5 Cool Fan Cover
6 Shelf
7 Foot
8 Water Box
9 Magnetic Seal
10 Door Frame
Before first Use
• Clean the appliance, and be thorough, especially in the interior (see „Cleaning and Care").
• In case the interior accessories are not correctly placed, rearrange them as described in chapter „Product
Description".
Tips for Energy Savings
• Try not to open the door too often, especially when the weather is wet and hot.
• Once you open the door, close it as soon as possible.
• Every now and then check if the appliance is sufficiently ventilated (adequate air circulation around the
appliance).
• Set thermostat from higher to lower settings as soon as possible {depends on how loaded the appliance is
ambient temperature etc).
• Before loading the appliance with packages of fresh foods, make sure they are cooled lo ambient tempera-
ture. For hot foods, please cool to room temperature before placing it in the cooler.
Operation
When the cooler works with full power, the two LEDs on the circuit board will flash. The red one shows the
power input status. The green one shows the output status of the cooling system. Meanwhile the fan inside the
cooler begins to work. When the door is opened, the light under the temperature adjuster will turn on automa-
tically. The temperature range for cooler is 8°C to 18°C. When the temperature is set on one certain point and
the temperature inside reaches this point, the automatic temperature control system begins to work and the
cooling system goes into linear temperature keeping status.
Note: Wait 3-5 minutes before restarting if you unplug the cooler. The unit may fail to operate properly if
restarted too quickly.
7

Product Description

Use and Operation