Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Alarm No.
-
Auto-stop with fas-
tening completion
-
Alarm for insufficient
fastening
-
Alarm for limit of the
fastening capacity
-
Maintenance alarm
-
Alarm for no com-
munication with
the PC
-
Indication that the
tool can communi-
cate with the PC
-
Check for the
lamp, indicator and
beeper (when the
battery cartridge is
installed)
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Selecting correct impact socket
Always use the correct size impact socket for bolts and
nuts. An incorrect size impact socket will result in inac-
curate and inconsistent fastening torque and/or damage
to the bolt or nut.
Installing or removing impact socket
Optional accessory
CAUTION:
Make sure that the impact socket
and the mounting portion are not damaged before
installing the impact socket.
CAUTION:
After inserting the impact socket,
make sure that it is firmly secured. If it comes out,
do not use it.
NOTE: The way of impact socket installation varies
depending on the type of the square drive on the tool.
Function
Status of the tool
The preset fasten-
ing torque has been
achieved and the
tool has stopped.
The preset fas-
tening torque has
not been achieved
because the switch
trigger was released
before completing
the fastening.
The battery power is
almost used up.
The number of drive
has been reached to
your preset number
for the maintenance.
No data commu-
nication while the
tool is connected to
the PC.
The tool is con-
nected to the PC
and able to commu-
nicate with.
The tool performs
the operation test
for the LED indi-
cator (green/red),
lamp, indicator and
beeper.
Status of the LED indicator/beeper
LED indicator
Lights up in green
for approximately
one second.
Lights up in red for
approximately one
second.
Blinks in red.
Blinks in yellow.
Blinks in yellow.
Blinks in green.
Lights up in green
and then red. After
that, the lamp turns
on for a while.
Tool with a hole on the square drive
For impact socket without O-ring and pin
Push the impact socket onto the square drive until it
locks into place.
To remove the impact socket, simply pull it off.
► Fig.13: 1. Impact socket 2. Square drive 3. Ring
spring 4. Hole
NOTE: Impact socket without O-ring and pin cannot
be used with tool without the ring spring.
For impact socket with O-ring and pin
Move the O-ring out of the groove in the impact socket
and remove the pin from the impact socket. Fit the
impact socket onto the square drive so that the hole in
the impact socket is aligned with the hole in the square
drive.
Insert the pin through the hole in the impact socket and
square drive. Then return the O-ring to the original posi-
tion in the impact socket groove to retain the pin.
To remove the impact socket, follow the installation
procedures in reverse.
► Fig.14: 1. Impact socket 2. O-ring 3. Pin
12 ENGLISH
Action to be taken
Beeper
–
A long beep
Retighten the
fastener.
A series of long
Replace the battery
beeps
with fully charged
one.
–
Reset the alarm
with the application
software.
–
Restart the appli-
cation software and
re-connect the USB
cable.
–
A series of very
short beeps
–
–
–
Werbung
