GreenWorks G24HT56 Bedienungshandbuch Seite 6

EN
7 TROUBLESHOOTING
Problem
The motor does
not start when
you pull the trig-
ger.
The machine
smokes during
operation.
There is too
much noise
and/or vibration
during operation.
8 TECHNICAL DATA
Voltage
Blade speed
Blade length
Cutting capacity
Weight (without
battery and charg-
er)
Measuered sound
pressure level
Guaranteed sound
power level
Vibration
Uncertainty
Battery model
Possible cause Solution
Make sure that
The battery pack
you tighlty install
is not installed
the battery pack
tightly.
in the machine.
The battery pack Charge the bat-
is out of power. tery pack.
1. Immediately
stop the ma-
chine.
The machine 2. Remove the
has damage. battery pack.
3. Contact the
service cen-
ter.
1. Stop the ma-
chine.
2. Remove the
battery.
The parts are
3. Inspect for
loose.
damage.
4. Check and
tighten loose
parts.
Do not use the
The parts have machine and
damage. contact the serv-
ice center.
24 V
-1
3000 (±10%) min
560 mm
18 mm
2.1 kg
89 dB(A), K =3 dB(A)
PA
98 dB(A)
2
≤2.5 m/s
2
1.5 m/s
G24B2, G24B4 and other BAF
series
English
Charger model
9 WARRANTY
(The full warranty terms and conditions can be found on
®
greenworks website)
®
The greenworks
and 2 years on batteries (consumer/private usage)
from the date of purchase. This warranty covers
manufacturing faults. A faulty product under warranty
might be either repaired or replaced. A unit that has
been misused or used in other ways then described
in the owner's manual might be rejected for warranty.
Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not
affected by any additional warranty offered by a dealer
or retailer.
A faulty product must be returned to the point of
purchase in order to claim for warranty, together with
the proof of purchase (receipt).
10 EC DECLARATION OF
CONFORMITY
Name and address of the manufacturer:
Name: Globe Technologies Europe GmbH
Address: Brunnenweg 17, 64331 Weiterstadt, Ger-
many
Name and address of the person authorised to compile
the technical file:
Name: Ralf Pankalla
Address: Brunnenweg 17, 64331 Weiterstadt, Ger-
many
Herewith we declare that the product
Category:
Model:
Serial number:
Year of Construc-
tion:
• is in conformity with the relevant provisions of the
Machinery Directive 2006/42/EC.
• is in conformity with the provisions of the following
other EC-Directives:
• 2014/30/EU
• 2000/14/EC & 2005/88/EC
• 2011/65/EU & (EU)2015/863
6
G24C, G24UC2, G24X2UC2,
G24X2UC4 and other CAF ser-
ies
warranty is 3 years on the product,
Hedge Trimmer
HTG330 (G24HT56)
See product rating label
See product rating label