Werbung
MOUNTING THE MICROWAVE OVEN
INSTALLATION
146
1.
Make sure all the packing materials are removed from
the inside of the door.
2.
Inspect the oven after unpacking for any visual damage
such as:
– Misaligned Door
– Damaged Door
– Dents or Holes in Door Window and Screen
– Dents in Cavity
If any of the above are visible, DO NOT use the oven.
3.
This Microwave Oven weighs 1
on a horizontal surface strong enough to support this
weight.
4.
The oven must be placed away from high temperature
and steam.
5.
DO NOT place anything on top of the oven.
6.
Keep the oven at least 20 cm away from both sidewalls
and 0 cm away from rear wall to ensure the correct
ventilation.
7.
DO NOT remove the turn -table drive shaft.
8.
As with any appliance, close supervision is necessary
when used by children.
9.
Make sure that the AC outlet is easily accessible so that
the plug can be removed quickly in an emergency.
Otherwise, it should be possible to disconnect the
device using a switch from the circuit. In this case, the
existing provisions of the electrical safety standards are
considered.
The product has to be correctly installed on earthed
socket with a single-phase AC (230 V/50 Hz).
WARNING! THIS APPLIANCE MUST BE EARTHED!
10. This oven requires 1.
service engineer is suggested when installing the oven.
CAUTION: This oven is protected internally by a 250V,
Amp Fuse.
3.6
kg and must be placed
45 W
k
for its input consultation with
10
Werbung
