SCANCOOL DA 320 X Bedienungsanleitung Seite 20

Problem
Appliance does not achieve re-
quired temperature.
Appliance is very noisy.
Condensation on outside of ap-
pliance.
Murmur of water is heard when
the appliance is working
Error code P1, P2 or P3.
Error code HA.
Error code LA.
Error code HAA.
Error code HLA.
Error code dA.
Alarm sounds.
Possible cause
Control panel is not set correctly.
Appliance is located near heat sources.
Stored items prevent proper closing of
door.
Appliance is placed too near to the wall or
to other objects.
Cooling compartment overloaded, filled
with hot items, filled in a way that pre-
vents proper air circulation, or items in
cooling compartment block the air inlet or
outlet.
Door opened and closed too often.
Door seal deformed or damaged.
Appliance is placed too near to the wall or
to other objects.
Appliance not in a stable position.
Loose part inside the appliance.
Normal phenomenon in hot and humid
environments.
Normal phenomenon as the coolant is circulating in the system.
Temperature probe failure, defrost probe
failure or humidity probe failure.
High temperature alarm (Temperature
higher than 27°C)
Low temperature alarm (Temperature
lower than -2°C)
High Humidity alarm (Humidity higher
than 95%
Low Humidity alarm (Humidity lower than
25%)
Door open.
Error code is displayed
Solution
Set temperature with control panel as de-
scribed in this manual.
Move appliance well away from heat
sources.
Reorder contents of cooling compartment
or remove several items to allow door to
close.
Keep a minimum distance of 10cm to wall
or other objects on all sides.
Remove several items, remove hot items,
reorder contents of cooling compartment
to allow air circulation, or remove items
which block the air inlet or outlet.
Keep door closed for a while.
Obtain a new door seal from an author-
ized seller and have it installed by a quali-
fied professional.
Keep a minimum distance of 10cm to wall
or other objects on all sides.
Bring appliance into a stable position.
Make sure that all feet/wheels are firmly
on the ground.
Have appliance checked and repaired by a
qualified professional.
Wipe appliance with a dry and soft cloth.
Wait until the error code vanishes auto-
matically.
Adjust the setting temperature
Adjust the setting temperature
Adjust the setting humidity
Adjust the setting humidity
Close the door.
Press the On/Off button.