After Use - SCANCOOL DA 320 X Bedienungsanleitung

will flash, while the buzzer will keep
beeping. UVC replacement re-
minder reset operation: in the alert
state, hold down the "
for 5 seconds to cancel the alert and
restart the timing.
2. How photocatalyst work
–
The panel controls
–
The 12v constant voltage
–
High frequency high voltage drive
–
Photocatalytic
Photocatalyst operation instructions
1. After the power supply of the beef cabi-
net is turned on, if the word UVC is not
displayed on the screen, please turn on
the Photocatalyst
2. Hold down the UVC button for about 5
seconds, turn on the UVC light, and the
word UVC appears on the screen.
3. The UVC motor rotates when the UVC
lamp is turned on.
UVC REPLACEMENT INSTRUCTION
1. Remove the screws and take away the
UVC box cover.
2. Loose the red and blue wire connector
and take away the UVC lamp.
3. Take a new UVC lamp and connect the
wire through the mounting hole.
4. Push the UVC lamp in the box.
5. Cover the UVC lamp box and fix with
screws.
NOTE:
•
Do not knock against the UVC lamp shell
during replacement and installation.
•
The effective service life of UVC lamp is
15 months, and it will be replaced after
reaching the service life.

4. After use

" button
Cleaning
•
Switch off and unplug the appliance be-
fore cleaning or maintenance.
•
Remove all items from the appliance.
Display elements
•
Do not clean the appliance with steel
wool, strong chemicals, alkali, abrasive,
or toxic agents, as they may damage the
surface of the appliance and pose a
health hazard.
•
During cleaning, do not approach sharp
elements (evaporator, condenser, etc.)
that could cause cutting injuries bare-
handed. Always use protective gloves.
•
Use little or no water during cleaning.
Make sure that no water enters the ap-
pliance while cleaning it.
•
Regularly wipe the inside and outside
surfaces of the appliance with a soft
damp cloth and a little mild detergent.
Dry with a soft dry cloth.
•
Regularly remove the shelves and S-
hooks and clean them with warm water,
a soft sponge, and a mild detergent. Dry
with a soft dry cloth.
•
Disinfect the inside of the appliance with
a mild disinfectant after cleaning.
•
Regularly clean the ventilation openings
with a soft brush or the crevice nozzle of
a vacuum cleaner.
•
To ensure a trouble-free performance
and to avoid excessive electricity con-
sumption, clean the condenser at the
back of the appliance at least once a year
with the crevice nozzle of a vacuum
cleaner.
•
If the condenser coil is not cleaned at
least 3 times per year, the efficiency of
the appliance will decrease significantly.
•
The appliance may only be used again or
stored after it is dried completely.